Screw the equipped bowl lid back onto the mouthpiece of the smaller bottle, and then fill the lower portion with cool, clean water approximately ¾ of the way. Fold the edges of aluminum foil around the cap to create the ideal seal, and then use a toothpick to poke a few small holes into the middle of the bowl for airflow. Take a piece of aluminum foil and gently mold it into a bowl shape before setting it into the hole that you’ve just made in the lid. Try to avoid melting the threads, as they will be necessary once it’s time to use this DIY bong. Take scissors or a lighter to cut or melt a hole into the middle of the lid. The last functional piece that you need to shape is the bowl, which in this case, is housed inside of the smaller bottle cap. Only a small amount is needed at first, and once it’s gone, set the piece you’ve just cut into the large cup AKA bucket, and from there, trim down the smaller one so that the mouthpiece reaches just a bit above the sides. Next, you will need to remove the bottom of the smaller bottle. This should result in the perfect cup shape with sides that aren’t leaning inwards. Now, take a sharp pair of scissors and remove the top portion of the largest bottle, just below the line that represents where the label would rest. Just bear in mind that the bottom will always be made from the largest plastic bottle. The inside of that chamber is filled with water, and as the water empties, the bottle fills up with smoke, and this close contact with a cool liquid helps to provide you with a much smoother hit.Īfter washing the containers, you will need to figure out which one will act as the base of your bong, and which one will be the chamber that houses the smoke and rests in the water. Now, this DIY bong is ready to be used, just pack the bowl with cannabis, remove the cap from the bottle, spark it up, and draw in a long hit through the mouthpiece.Ī gravity bong works off the natural forces of the earth’s pull, to draw the thick cloud of cannabis smoke down into the depths on a chamber. Once you are satisfied with the depth of the bowl, it’s time to give the bong some airflow by using a toothpick to poke several tiny holes into the center of the aluminum foil. Now, get out your piece of aluminum foil and use your fingertips to mold it into a bowl shape by pressing it gently into the middle of the hole you’ve just cut. Use a sharp pair of scissors to carefully remove a small circle of plastic from the lower half of the side of the bottle.
#How to make a homemade pipe with a water bottle how to
The bottle pipe isn’t going to offer the smoothest hit on this list, but it also doesn’t require access to clean water, and it’s often the easiest piece to throw together for your first time learning how to make a bong.įirst, thoroughly wash the plastic then pat it dry to ensure that you aren’t inhaling anything that could be hazardous to your lungs.Ĭreate a hole that should be close to the size of a loonie so that it works as the perfect bowl. There are even some things that you can do to reduce the risk, like introducing water to the equation to keep the plastic cooler, and to help you out, we’re going to explain the three best ways to make a DIY bong with a bottle. Plastic is never an ideal piece of equipment in a process that requires heat, but sometimes we’re left with few choices, and it can work well in a pinch.
0 kommentar(er)
